When selecting welding robots for welding production, try to install robot safety fences on the outside of the welding robot installation to prevent irrelevant personnel from approaching; when operating the welding robot, the staff should also wear protective equipment; the start button is set on the robot Safe location to avoid leaving safety hazards. In the process of spot welding, only point position control is required, and there is no strict requirement for the moving track of the welding clamp between points. It is precisely because of this that the welding robot must not only have sufficient load capacity, but also must be fast when shifting from point to point, move smoothly, and position accurately to reduce the shifting time and improve work efficiency.

The main purpose of the welding robot safety fence is to set up protective measures on the periphery of the production. Part or all of the aluminum profile protective fences are built to ensure the safety of personnel and equipment. Some areas will install doors or leave passages to facilitate the entry and exit of goods and personnel maintenance.

The load capacity required for the welding robot depends largely on the type of welding tongs used. Usually, for welding tongs separated from the transformer, a welding robot with a load of 30-45kg is sufficient. However, on the one hand, this kind of welding tongs has a long secondary cable and large power loss, which is not conducive for the robot to extend the welding tongs into the workpiece for welding; on the other hand, the cable keeps swinging with the movement of the welding robot, and the cable is damaged quickly. , So it has been gradually replaced with an integrated welding gun.

The so-called in order to avoid environmental factors from causing adverse effects on the welding robot and prolong its service life, try to install the welding robot in a waterproof, dry, and less dusty place. And it is required that the control cabinet and the welding machine should be kept at a distance from the ground as much as possible.

After the welding robot is installed, its safety protection measures are also necessary. The purpose of replacing manual robots with robots is to quickly do some repetitive actions, and if someone approaches during the movement, it is likely to cause major safety accident.